Mini road roller is widely used in highway construction. The correct use is also to protect human life. When using, going up and down will damage the equipment parts. Remember not to change fast gears, which will cause the equipment to stall and the engine will suffer. Therefore, correct use is very important. It is recommended that the driver read carefully and familiarize themself with the performance of the equipment before using the mini roller compactor.
1. During operation, the roller compactor should start before it starts to shake. The internal combustion engine should be set to medium speed first, and then adjusted to high speed. Pay attention to the work load during the running-in period. The work load during the running-in period should generally not exceed 80% of the rated work load, and proper workload should be deployed to prevent overheating caused by the machine’s long-term continuous operation.
2. The road roller machine must not engage with vibration when driving at high speed. Pay attention to frequently check the instigation of each instrument, if it is abnormal, stop it in time to eliminate it, and end the operation before the cause is found and the fault is not eliminated.
3. The engine should be stopped first when shifting and reversing, and the engine speed should be reduced when shifting.
4. When rolling a soft roadbed, you should first roll it 1-2 times without vibration, and then vibrate it.
5. When stopping, the vibration should be stopped first, then the reversing mechanism should be placed in the middle position, the transmission should be placed in neutral, the hand brake lever should be pulled up, and the internal combustion engine should be turned off after idling for a few minutes.
6. The adjustment of the reversing clutch, shock clutch and brake should be carried out after the main clutch is disengaged.
7. When going up or downhill, fast gears are not allowed. In sharp turns, including articulated vibratory road rollers when rolling in small turns, fast gears are strictly prohibited.
8. It is strictly forbidden to vibrate the mini road roller on a solid ground, keep the machine clean, adjust and tighten loose parts in time to prevent the loose parts from aggravating the wear of the parts or causing the loss of the parts. When rolling, the vibration frequency should be consistent. For the adjustable mini roller compactor, the vibration frequency should be adjusted first before operation. Do not adjust the vibration frequency without shaking. Other operation requirements should meet the requirements of the roller.
站点标题 